The 03-P355 Cyclops remote controlled immobiliser is New Zealand standards approved and may provide keyless entry and can be upgraded to provide full alarm functions via siren and sensor additions
Two independent circuits of immobilisation - 30 Amp relays built in
Remote controlled - code hopping system with 1,800,000,000,000,000,000 code combinations
Holds memory up to 3 remote controls - (oldest programmed is rolled off after programming 4th remote)
Hazard lights flash for confirmation of arm/disarm
Auto arming & re-arming - 39 seconds after ignition turn off
Independent hazard fuse - main unit does not loose power if thief short circuits an indicator
Concealed plug in assembly - unit cannot simply be unplugged
Override - PIN code is entered by means of ignition switch
Bright flashing LED - indicates status of immobiliser
Hot wire warning - hazard lights flash for 5 seconds
Optional doors, bonnet and boot protection - horn sounds if connected
Central locking outputs
Optional boot release - output available to activate boot release relay
Optional door re-lock function. Optional anti-hijack function
High current negative output for interior light - drives resistive loads up to 2amps
Wide range operating voltage - 9 volts to 18 volts - Extra low operating current - less than 10 mA in the armed mode
Reverse polarity protected. Load dump protected
Fail safe immobilisation circuitry - if system loses +12 volts or one ground while driving, engine continues running
Normally open immobilisation relay contacts - ensuring that engine cannot be started if total power removed to system
NZSA Certified & Manufactured in an ISO 9002 facility